6 Danbury Rd
New MilfordCT 06776
| Driving directions
Auto Technic LLC
| (860) 350-8407










About us photo



BMW Service Intervals

All BMWs Late 1999 to Present:

Brake Fluid Flush: 2 years
Coolant Flush: 2 years
Power Steering Flush: 3 years
Inspection I: 30,000 miles
Inspection II: 60,000 miles

3 Series from 1992-1999 (including Z-cars),
5 Series from 1992-1999,
7 Series from 1994-1999, and
8 Series:

Brake Fluid Flush: 2 years
Coolant Flush: 2 years
Power Steering Flush: 3 years
Inspection I: 20,000 miles
Inspection II: 40,000 miles

3 Series from 1988-1992,
5 Series from 1988-1992,
6 Series from 1988-1992, and
7 Series from 1988-1992:

Brake Fluid Flush: 2 years
Coolant Flush: 2 years
Power Steering Flush: 3 years
Inspection I: 20,000 miles
Inspection II: 40,000 miles

We recommend conventional oil changes every 3,000 miles, and synthetic changes every 5,000 miles.

BMW Inspection I

The BMW Inspection 1 Service is the smaller of the two inspection services recommended by BMW.  It includes all of the items that assures safety and full functionality of your vehicle. The items that are generally checked are listed below. We carry all the BMW parts you need to complete the

Undercarriage

  1. Change engine oil and filter oil while engine is at normal operation temperature.
  2. Check transmission for leaks.
  3. Check rear axle for leaks.
  4. Visually check fuel tank, lines, and connections for leaks.
  5. Check condition, position, and mounting of exhaust system. Examine for leaks.
  6. Check power steering system for leaks.
  7. Check overall thickness of front and rear disc brake pads.
  8. Examine brake disc surfaces.
  9. Clean brake pad contact points in calipers.
  10. Grease wheel center hubs.
  11. Check steering for absence of play, condition of suspension track rods, front axle joints, steering linkage, and joint disc.
  12. Check front control arm bushing for wear.
  13. Check brake and clutch system connectors and lines for leaks, damage, and incorrect positioning.
  14. Check for free movement of the parking brake cables. Adjust parking brake if necessary.
  15. Check all tire pressures (including spare). Correct if necessary.
  16. Check condition of tires (outer surfaces (left/right)), tread wear and pattern; In case of uneven tread wear readjust wheel alignment if required.

Engine Compartment

  1. Read out diagnostic system
  2. Check engine cooling system/heater hose connections for leaks.
  3. Check coolant level and antifreeze protection level; add coolant if necessary.
  4. Check level of brake and clutch fluid in reservoir; add fluid if required.
  5. Check windshield washer fluid level and antifreeze protection. Fill up and/or correct if necessary.
  6. Check air conditioner for operation.
  7. Reset Service Indicator.

Body/Electrical Equipment

  1. Check battery electrolyte level and add distilled water if required.
  2. Perform batter load test.
  3. Check lighting system, i.e. headlights, foglights, parking, backup, license plate, interior (including map reading lights), glove box, flashlight, illuminated makeup mirrors, luggage compartment lights.
  4. Check instrument panel and dashboard illumination.
  5. Check all warning/indicator lights, check control.
  6. Check turn signals, hazard warning flashers, brake lights, horns, headlight dimmer/flasher switch.
  7. Check wiper and washer system(s); wiper blades, washer jet positions.
  8. Check condition and function of safety belts.
  9. Oil hood, trunk/tailgate, and door hinges.
  10. Grease hood, trunk/tailgate and door latches. Check operation of all latches.
  11. Check central locking/double lock.
  12. Replace microfilter or Acc. Cabin Filter.
  13. Check heater/air conditioner blower, rear window defogger.
  14. Check rear view mirrors
  15. Visually examine the SRS airbag units for torn cover, obvious damage or attachment of decals, decorations, or accessories.

Final Inspection

  1. Road test with check of brakes, suspension, steering, clutch/manual transmission or automatic transmission

BMW Inspection II

The Inspection 2 Service is the larger of the two Inspection Services and basically includes all of the items performed on the Inspection I along with some extras like differential oil change; fuel filter and air filter replacements; spark plug replacement.

Undercarriage

  1. Change engine oil and filter oil while engine is at normal operation temperature.
  2. Check transmission for leaks.
  3. Check rear axle for leaks.
  4. Visually check fuel tank, lines, and connections for leaks.
  5. Check condition, position, and mounting of exhaust system. Examine for leaks.
  6. Check power steering system for leaks.
  7. Check overall thickness of front and rear disc brake pads.
  8. Examine brake disc surfaces.
  9. Clean brake pad contact points in calipers.
  10. Grease wheel center hubs.
  11. Check steering for absence of play, condition of suspension track rods, front axle joints, steering linkage, and joint disc.
  12. Check front control arm bushing for wear.
  13. Check brake and clutch system connectors and lines for leaks, damage, and incorrect positioning.
  14. Check for free movement of the parking brake cables. Adjust parking brake if necessary.
  15. Check all tire pressures (including spare). Correct if necessary.
  16. Check condition of tires (outer surfaces (left/right)), tread wear and pattern; In case of uneven tread wear readjust wheel alignment if required.
  17. Check thickness of parking brake linings.
  18. Half-shafts; check for leaks at flexible boots.
  19. Inspect entire body according to terms of rust prevention limited warranty.

Engine Compartment

  1. Read out diagnostic system
  2. Check engine cooling system/heater hose connections for leaks.
  3. Check coolant level and antifreeze protection level; add coolant if necessary.
  4. Check level of brake and clutch fluid in reservoir; add fluid if required.
  5. Check windshield washer fluid level and antifreeze protection. Fill up and/or correct if necessary.
  6. Check air conditioner for operation.
  7. Reset Service Indicator.
  8. Replace spark plugs.
  9. Replace intake air cleaner element.

Body/Electrical Equipment

  1. Check battery electrolyte level and add distilled water if required.
  2. Perform batter load test.
  3. Check lighting system, i.e. headlights, foglights, parking, backup, license plate, interior (including map reading lights), glove box, flashlight, illuminated makeup mirrors, luggage compartment lights.
  4. Check instrument panel and dashboard illumination.
  5. Check all warning/indicator lights, check control.
  6. Check turn signals, hazard warning flashers, brake lights, horns, headlight dimmer/flasher switch.
  7. Check wiper and washer system(s); wiper blades, washer jet positions.
  8. Check condition and function of safety belts.
  9. Oil hood, trunk/tailgate, and door hinges.
  10. Grease hood, trunk/tailgate and door latches. Check operation of all latches.
  11. Check central locking/double lock.
  12. Replace microfilter or Acc Cabin Filter.
  13. Check heater/air conditioner blower, rear window defogger.
  14. Check rear view mirrors
  15. Visually examine the SRS airbag units for torn cover, obvious damage or attachment of decals, decorations, or accessories.

Final Inspection

  1. Road test with check of brakes, suspension, steering, clutch/manual transmission or automatic transmission
 
Privacy Policy Close [X]
PRIVACY NOTICE

This privacy notice discloses the privacy practices for www.autotechnicct.com.
This privacy notice applies solely to information collected by this web site. It will notify you of the following:

  1. What personally identifiable information is collected from you through the web site, how it is used and with whom it may be shared.
  2. What choices are available to you regarding the use of your data.
  3. The security procedures in place to protect the misuse of your information.
  4. How you can correct any inaccuracies in the information.

Information Collection, Use, and Sharing
We are the sole owners of the information collected on this site. We only have access to/collect information that you voluntarily give us via email or other direct contact from you. We will not sell or rent this information to anyone.

We will use your information to respond to you, regarding the reason you contacted us. We will not share your information with any third party outside of our organization, other than as necessary to fulfill your request, e.g. to ship an order.

Unless you ask us not to, we may contact you via email in the future to tell you about specials, new products or services, or changes to this privacy policy.

Your Access to and Control Over Information
You may opt out of any future contacts from us at any time. You can do the following at any time by contacting us via the phone number given on our website:

  • See what data we have about you, if any.
  • Change/correct any data we have about you.
  • Have us delete any data we have about you.
  • Express any concern you have about our use of your data.

Security
We take precautions to protect your information. When you submit sensitive information via the website, your information is protected both online and offline.

Wherever we collect sensitive information (such as credit card data), that information is encrypted and transmitted to us in a secure way. You can verify this by looking for a closed lock icon at the bottom of your web browser, or looking for "https" at the beginning of the address of the web page.

While we use encryption to protect sensitive information transmitted online, we also protect your information offline. Only employees who need the information to perform a specific job (for example, billing or customer service) are granted access to personally identifiable information.

The computers/servers in which we store personally identifiable information are kept in a secure environment.

If you feel that we are not abiding by this privacy policy, you should contact us immediately via telephone at (860) 350-8407.